250 bar Drive train fault (check the high-pressure valves and purge valve and the screw connections in the pressure line); dis- 250 bar Turbo-clutch valve (4V4) or clutch valve (4V5) leaking D ANGER : Support the tractor safely on four support trestles (high pressure measurement) Connect a pressure gauge with a rating higher than 550 bar to the PH measurement connection 250 bar Clutch valve (4V5) leaking (replace) PH 550 bar 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- PH N OTE : Before checking the clutch valve (4V4) the clutch pedal must be calibrated.
Checking the turbo-clutch valve (4V4) Mechanically block the turbo-clutch valve (screw in the hex. socket head screw) 4. Attach the auxiliary lever and drive the transmission against high pressure. Remove the right rear wheel as well as the cover panels 3. Engine speed greater than 1400 rpm (PVM activated signal) Checking the high-pressure circuit in the valve block The following tasks must be carried out: 2. Apply the handbrake firmly and depress the footbrake Remove the screw plugs on the T connection 1005 - Overall system/transmission E - Measuring and testing Measurement (example) 34 T000736 Version 1 07-11-2007 Conducting the test 1. Start engine.
see §11 E - Measuring and testing PH T connection Possible cause of fault 250 bar No oil is flowing from T Drive train fault (check the high-pressure valves and purge valve and the screw connections in the pressure line); dis- mantle the drive train 250 bar Oil is flowing from T Turbo-clutch valve (4V4) or clutch valve (4V5) leaking PH T connection Possible causes of the fault 250 bar Oil is flowing from T Clutch valve (4V5) leaking (replace) 550 bar Oil is flowing from T Electrical check of TK valve Y004