1220 - Transmission / Live PTO G - Repair I003692 Fig. 55. I003693 Fig. 56. I003694 Fig. 57. I003695 Fig. 58. 31 T001262 Version 1 07-11-2007 Press the inner ring of the tapered roller bearing (123) on to the shaft (120). Fit the washer (120). Put the circlip (121) in place. Grease two setscrews (125) with X 903.050.084 syn- thetic bonding agent and turn them until they reach the in- ner ring of the tapered roller bearing (123). Washer (122) must become tight. Thread the needle bearing (109), spacer (110) and needle bearing (109) onto the shaft (120). Insert the shaft (120). Fit the washer (108). Put the circlip (107) in place. Place the new compact seal rings (219) in the cylinder (217).
Place the new O-ring (218) in the groove of the cylinder (217). Grease the sealing elements. Insert the piston (222) with the pressure spring (221) in the manner shown in the cylinder (217). N OTE : The compact seal ring (219) consists of two parts, O-ring on the outside and a piston guide tape inside. Place the new compact seal rings (220) in the cylinder (226). Place the new O-ring (218) in the groove of the cylinder (226). Grease the sealing elements. Insert the piston (224) with the pressure spring (221) in the manner shown in the cylinder (226). N OTE : The compact seal ring (220) consists of two parts, O-ring on the outside and a piston guide tape inside. 919 .. 0101-1000 925 ..
1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- G - Repair