922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- 0000 - Overall system/tractor B - Faults 05-10-2009 Continuation in emer- Circuit diagram 04.1.85 B010 - Sensor, engine speed Engine speed sensor does not Fault code DIN brief description Cause Consequences Reference FENDIAS/Note 56 Fault code DIN brief description Cause Consequences Reference FENDIAS/Note 04.1.85 B010 - Sensor, engine speed Engine speed sensor does not supply plausible speed curves. Output speed increase or decrease is outside limits.
Continuation in emer- gency mode possible Circuit diagram Transmission control system 04.1.86 B008 - Sensor, high-pressure 1 B039 - Sensor, high-pressure 2 Plausibility error in both pressure sensors TMS is switched off Circuit diagram Transmission control system 04.1.87 S079 - Switch, steering column Plausibility error at F/R switch, quick reverse F/R switch inoperable, quick reverse on steering wheel adjustment, S079 switch, Check quick reverse Chapter 9000 Reg.
E 04.1.89 B009 - Discharge temperature sensor Plausibility error, transmission temperature Circuit diagram Transmission control system 04.1.8B B014 - Sensor, collecting shaft B015 - Sensor, bevel pinion Plausibility error, stationary con- trol hydrostatic pulse Stationary control off until next key reset EOL programming 7.63, version 04/09 or later 04.1.8C B014 - Sensor, collecting shaft B015 - Sensor, bevel pinion Plausibility error, stationary con- trol hydrostatic direction Stationary control off until next key reset EOL programming 7.63, version 04/09 or later 04.1.8F Currently selected tyre circumfer- ence is too small - The speed display is no longer correct in certain circumstances - Transmission controls no longer working cor- rectly in certain circum- stances (e.g.
TMS, final speed control, cruise control) Enter larger tyre cir- cumference 04.1.94 A039 - MFA, multifunction armrest A050 - ECU, basic control unit Faulty CAN communication between e-box and CAN joystick 04.1.A1 A009 - Actuator unit Turn angle is not reached within 2 seconds. Continuation in emer- gency mode possible Mechanical check: check smooth adjust- ment action in emer- gency mode. Refer to Service Infor- mation 26/04