I006254 Fig. 3. Operating principle: The common rail system is very sensitive to dirt and water. For this reason this filter is fitted to all common rail engines, and in addition the filter is fitted with a B091 sensor, which monitors water in the fuel. Depending on the model of tractor and its chassis number, different models of filter are fitted; the diagram shows for all the models of tractor the first model in which the transition to a filter with an integral manual pump was made. When the water in the filter reaches the maximum level, a sensor causes a warning message to be displayed on the instrument panel. The water must then be drained off without delay.
This pre-filter has the following function when contaminated fuel passes through it: The water that is found in the fuel is collected in the sight glass of the filter. The coarser dirt particles are filtered out by the filter (exchange element). N OTE : Refer to the care and maintenance chapter in the operator’s manual. 2 Water sedimentor (pre-filter) Sight glass with B091 - Sensor, water in fuel Water sedimentation greater than 98% Water sedimentor with pre-filter 2. Fuel outlet to the system 2060 - Engine/fuel system A - General 1. Fuel inlet from the tank Mechanical drain valve 10 T002071 Version 2 20-10-2009 Filter unit 30 μm Check Chassis Range!