0000 - Overall system/tractor B - Faults 75 05-10-2009 enhanced control cause: brief control pressure dips or oil too viscous at very low tem- peratures) and locks 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 ..
1001- Fault code DIN brief description Cause Consequences Reference FENDIAS/Note 09.1.4B A039 - MFA, multifunction armrest Button, auto front power lift Auto front power lift button faulty (output via TeachIn) 09.1.A2 Y070 [FKH] - Cut-off valve, front power lift enhanced control EEPROM error (valve) Valve moves to neutral and locks 09.1.A3 Y070 [FKH] - Cut-off valve, front power lift enhanced control RAM Test _ Valve moves to neutral and locks Pilot pressure OFF EOL programming 09.1.A4 Y070 [FKH] - Cut-off valve, front power lift enhanced control Flash Test _ Valve moves to neutral and locks Pilot pressure OFF EOL programming 09.1.A5 Y070 [FKH] - Cut-off valve, front power lift enhanced control Incorrect valve code (SA/DA) for selecting EOL EOL programming 09.1.B0 B040 - Sensor, front power lift position Position sensor not calibrated No control possible, operable only via external button Calibration code "9002" 09.1.B2 A039 - MFA, multifunction armrest Setpoint potentiometer, front power lift Setpoint value potentiometer not calibrated Setpoint values cannot be set, only position con- trol possible Calibration code "9001" 09.1.C0 A039 - MFA, multifunction armrest MFA not fitted No auto mode possible, operable only via external button 09.1.C1 A039 - MFA, multifunction armrest Terminal Terminal not fitted Configuration cannot be changed 09.1.CE A007 - Instrument panel Temperature limit warning Is not stored 09.1.CF A007 - Instrument panel Temperature limit warning Is not stored 09.1.E0 Y070 [FKH] - Cut-off valve, front power lift enhanced control Valve does not report to V bus Valve moves to neutral and locks 09.1.E2 Y070 [FKH] - Cut-off valve, front power lift enhanced control Undervoltage (where U Valve moves to neutral and locks 09.1.E3 Y070 [FKH] - Cut-off valve, front power lift enhanced control Overvoltage, safe (where U > 18 V) Valve moves to neutral and locks 09.1.E4 Y070 [FKH] - Cut-off valve, front power lift enhanced control Valve actuator falls short (frequent cause:
brief control pressure dips or oil too viscous at very low tem- peratures) Valve moves to neutral and locks