ELECTRONICS MH6.6 / MH8.6 4-26 ESX CODING Schematic Description Coding of the ESX controller is performed at the factory of the manufacturer before the machines are delivered. The cable harness to the ESX comprises connec- tors XC1, XC2 and XC3. Connector XC1 permits changing the SAE control to other control systems by means of different cod- ing jumpers. Connector XC2 is equipped with coding jumpers for boom-adjusting equipment or for mono-block boom equipment. If the boom (adjustable boom versus mono-block boom or vice versa) is replaced, the coding jump- ers must also be replaced. Fig. 1 Connector XC3 is provided with the standard cod- ing jumpers.
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)