0-24 SAFETY INSTRUCTION MH6.6 / MH8.6 Fire prevention Checking for leakages: Removal of flammable substances: - Leakages of fuel, hydraulic oil and lubricants may cause fires. - Spilt fuel or lubricant, waste, lubri- cating grease, dirt, coal dust de- posits and other flammable sub- stances may cause fires. - Check whether clips are missing or loose, hoses are kinked, lines or hoses rub against one another, the oil cooler is damaged or oil cooler flange screws are loose, allowing oil to escape. - To prevent fires, the machine must be checked and cleaned once a day. Any spillages or deposits of flammable substances must be cleared away immediately.
- Missing, loose or damaged clips, lines, hoses, oil coolers or oil cooler flange screws must be re- placed, tightened or repaired. Checking the ignition key function: - If the engine is not shut off when fire breaks out, the fire will spread, impeding fire-fighting operations. - High-pressure lines must not be bent or hammered. - Before starting daily machine op- erations, the ignition key must be checked for correct functioning. - Never install bent or damaged lines, tubes or hoses. Start up the engine and run it at a low idling speed. Checking for short-circuits: - Short-circuits may cause fires. - Ensure that all electrical connec- tions are clean and have a firm fit.
To confirm that the engine is shut off, turn ignition key to OFF position. - Any irregularities that are detected must be rectified before the ma- chine is put into operation. Check before each shift or after ca. ten operating hours whether electric cables or lines are loose, kinked, hardened or worn through. Checking heat shields: - Check before each shift or after ca. ten operating hours whether termi- nal caps are missing or damaged. The absence of heat shields or any damage to them may result in fire breaking out. - Never start up the machine if ca- bles or lines are loose, kinked, etc. Damaged or missing heat shields must be repaired or replaced before the machine is put into operation.
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)