MH MH6.6/MH8.6 — GB COPERTINA.fm

MH6.6 / MH8.6 HYDRAULICS 5-77 Description Solenoid valve Y21.4 (2) operates the gearshift function. The control block is located in the undercarriage frame above the multi-disk clutch. Shifting func- tions are performed by pilot pressure. The block is also connected to a reservoir line. When the parking brake is released, the valve al- ways directs pilot pressure to one of the two multi- disk clutches. Which of the clutches is pressurized depends on whether the solenoid is on or off. When the solenoid is off, pilot pressure is admitted to the clutch for 2 nd forward gear. When it is on, pilot pressure is admitted to the clutch for the 1 st gear.

The valve housing (1) is equipped with four sole- noid valves, pressure switch 106 and diaphragm accumulator 104. Solenoid valve Y16 (1) actuates the parking brake. The parking brake function is ensured by means of the multi-disk clutches in the speed-change gear- box. When both clutches are without pressure, the parking brake function is ensured by the multi-disk speed-change gearbox. Solenoid valve Y62 (3) is used for applying and releasing the floating-axle blocking. Without current in the solenoid, the floating axle is blocked since the valves integrated in the cylinders are without pressure.

When the solenoid is ener- gized, the control piston is shifted so that the the blocking valves in the cylinders are unblocked by the pilot pressure. In the deenergized state, the control piston of Y16 is connected to the reservoir. A gear engaged be- forehand and the respective clutch are switched without pressure. Solenoid valve Y21.2 (4) is used to engage the creep-speed gear of the travel oil motor. The switching pressure in the clutch escapes to- gether with the accumulator pressure through the outlet restrictor into the reservoir line. When the creep-speed gear is engaged, the sole- noid is energized and the control piston sends pilot pressure to the regulator of the travel oil motor.

The control piston in the regulator is displaced and the travel high pressure acts on the adjusting pis- ton with the drive unit swivelling to the Vgmax posi- tion. The travel oil motor has then maximum. dis- placement volume and the machine moves at creep speed. When the parking brake is released, voltage ar- rives to the magnetic coil so that the control piston lets the pressure of the piloting system go through, as switching pressure, in a clutch of the transmis- sion. Also, the accumulator is charged opening the switching contact of pressure switch S16.1. The relevant clutch and discs open and deactivate the function of the parking brake in the transmission.

Il Pressure switch S16.1 (106) controls the pres- sure actuating the clutches in the transmission. When the parking brake is locked and the parking brake is deactivated, the switching contact of the pressure switch must be closed, otherwise an error signal is generated. An emergency release circuit on the solenoid side can be used in the event of electrical supply failure to shift the control piston mechanically in such a way that the pilot pressure can release a multi-disk clutch. The pressure accumulator (104) with its accumu- lated pressure delays the pressure drop in a multi- disk clutch after activation of the parking brake so that the braking action sets in smoothly.

Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)