MH MH6.6/MH8.6 — GB COPERTINA.fm

MH6.6 / MH8.6 TROUBLESHOOTING AND REPAIR 7-7 9272 Slewing delay key not responding 9273 Slewing delay key, display fault left LED 9274 Slewing delay key, display fault right LED 9281 Operating scheme coding plug, cable parting 9282 Operating scheme coding plug, dual short circuit after supply voltage 9283 Operating scheme coding plug not available 9286 Boom adjusting mechanism coding plug, cable parting 9287 Boom adjusting mechanism coding plug, short circuit after supply voltage 9288 Boom adjusting mechanism coding plug not available 9291 Servo control system changeover switch, cable parting 9292 Servo control system changeover switch, short circuit after supply voltage 9293 Servo control system changeover switch not available 9301 Right joystick failure 9302 Right joystick, message counter faulty 9303 Right joystick, CAN communication faulty 9304 Right joystick, initialization message faulty 9305 Right joystick, faulty EEPROM access 9306 Right joystick, inverse message failure 9307 Right joystick, inverse message defective 9308 Right joystick, message counter of inverse message faulty 9309 Right joystick, faulty processor 9310 Right joystick, Alive message failure 9312 Right joystick, pushbutton 1 defective 9313 Right joystick, pushbutton 2 defective 9314 Right joystick, pushbutton 3 defective 9315 Right joystick, pushbutton 4 defective 9316 Right joystick, pushbutton 5 defective 9319 Right joystick, sensor in "X" direction not installed 9320 Right joystick, sensor in "X" direction defective 9321 Right joystick incompatible status in "X" direction 9322 Right joystick, sensor in "Y" direction not installed 9323 Right joystick, sensor in "Y" direction defective 9324 Right joystick incompatible status in "Y" direction 9331 Left joystick, failure 9332 Left joystick, message counter faulty 9333 Left joystick, CAN communication faulty 9334 Left joystick, initialization message faulty 9335 Left joystick, faulty EEPROM access 9336 Left joystick, inverse message failure Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)