MH MH6.6/MH8.6 — GB COPERTINA.fm

8-122 REPAIR INSTRUCTIONS MH6.6 / MH8.6 Removing the adjusting cylinder Weight of the adjusting cylinder: 271 kg MH6.6 289 kg MH8.6 Fig. 3 - Drive the pin out of its housing using a hammer and a brass drift. - Remove spacers (3) when removing pin (2). Wear protective equipment such as goggles and helmet to protect your- self against metal splinters resulting from hammering. - Retract the piston rod completely into the adjust- ing cylinder. Secure the rod to the cylinder barrel to prevent it from moving. - Shut off the engine and depressurize all hydrau- lic components by moving the cylinders with the control levers gently in both directions, the en- gine being off, but the ignition on.

- Shut off the engine. - Secure the machine against inadvertent starting, e.g. with a warning sign attached to the machine. - Place the equipment safely on the ground and secure the machine against inadvertent move- ments. - Detach the hoses from the pipes and close the hose, pipe and cylinder openings with plugs. - Remove the leakage oil lines, if any. - Place a piece of squared timber between the adjusting cylinder and the lower boom section. Fig. 4 - Loosen screw (4) which secures pin (5). Fig. 2 - Drive the pin out of its housing using a hammer and a brass drift. - Remove spacers (6) when removing pin (5). - Remove screw (1) which fixes pin (2) to the boom.

- Lift the adjusting cylinder with a crane. Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual) 24 mm Hammer Brass drift