Cummins — 4021389

B3.9, B4.5, B5.9 Industrial Overhead Set Section 6 - Maintenance Procedures at 1000 Hours or 1 Year Page 6-5 To reduce the possibility of engine or pin damage, be sure the timing pin is disengaged. CAUTION Mark the vibration damper and rotate the crankshaft 360 degrees. Adjust the valves as indicated in the illustration. Set only valves indicated by the arrows (E = exhaust, I = intake). Do not set valves that are not indicated. Torque Value: 24 N•m [ 18 ft-lb ] Six-Cylinder Engine Valve Adjustment Make sure the engine is at top dead center (TDC) for cylinder number 1. Set only the valves indicated by the arrows in the illustration (E = exhaust, I = intake).

Holding the locknut steady with the wrench, adjust the valve clearance with the screwdriver or Allen wrench. Tighten the locknut, and measure the valve lash again. Torque Value: 24 N•m [ 18 ft-lb ] To reduce the possibility of engine or pin damage, be sure timing pin is disengaged. CAUTION Mark the pulley, and rotate the crankshaft 360 degrees.