Troubleshooting Symptoms Charts B3.9, B4.5, B5.9 Industrial Page TS-24 Section TS - Troubleshooting Symptoms Engine Noise Excessive Cause Correction STEP 1 Fan drive belt is loose, tight, or not in alignment ............. Check the fan drive belt. Refer to Procedure 103-002 (Drive Belts) in Section 3. OK Go To Next Step Refer to Procedure 018-003 (Lubricating Oil Recommendations and Specifications) in Section V. STEP 2 Lubricating oil is thin or diluted ............. OK Go To Next Step Inspect the vibration damper. Refer to Procedure 001-051 (Vibration Damper - Rubber) or Procedure 001-052 (Vibration Damper - Viscous) in Section 7. STEP 3 Vibration damper is damaged .............
OK Go To Next Step Check for loose or damaged piping connections and missing pipe plugs. Check the turbocharger and exhaust manifold mounting. Refer to Procedure 010-058 (Air Intake Piping) in Section 3. STEP 4 Air intake or exhaust leaks ............. OK Go To Next Step STEP 5 Air intake or exhaust piping is contacting the ............. Inspect the air piping, chassis, and cab for contact points. Refer to the OEM service manual. chassis or cab OK Go To Next Step Check the air intake system for restriction. Clean or replace the air filter and inlet piping as necessary. Refer to Procedure 010-059 (Air Cleaner Restriction) in Section 4.
STEP 6 Air intake system restriction is above specification ............. OK Go To Next Step Refer to the Coolant Temperature is Above Normal - Sudden Overheat or the Coolant Temperature is Above Normal - Gradual Overheat symptom tree. STEP 7 Coolant temperature is above specification ............. OK Go To Next Step STEP 8 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step