B3.9, B4.5, B5.9 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-41 Engine Will Not Reach Rated Speed (RPM) Cause Correction STEP 1 Vehicle speed is too low for adequate cooling with ............. Reduce the engine load. Increase the engine (fan) rpm by downshifting. high engine load OK Go To Next Step STEP 2 Tachometer is not calibrated or is malfunctioning ............. Compare the tachometer reading with a handheld tachometer. Replace the tachometer as necessary. Refer to the OEM service manual. OK Go To Next Step Tighten the fittings, repair plumbing, replace wastegate diaphragm.
Refer to the OEM service manual or a Cummins® Authorized Repair Location. STEP 3 Air-fuel tube leaking, wastegate diaphragm ............. ruptured, or wastegate plumbing damaged OK Go To Next Step STEP 4 Charge air cooler restricted (if equipped) ............. Inspect the air cooler for internal and external restrictions. Replace the restricted cooler if necessary. Refer to the OEM service manual. OK Go To Next Step Check the flow through the filter to locate the source of the restriction. Refer to the OEM service manual. STEP 5 Fuel supply is not adequate ............. OK Go To Next Step STEP 6 Exhaust back pressure too high ............. Measure and correct if above specification.
Refer to a Cummins® Authorized Repair Location. OK Go To Next Step Check the fuel lift pump for correct operation. Check the pump output pressure. Replace the fuel lift pump if necessary. Refer to a Cummins® Authorized Repair Location. STEP 7 Fuel lift pump is malfunctioning ............. OK Go To Next Step STEP 8 Vehicle parasitics are excessive ............. Check the vehicle brakes for dragging, transmission malfunction, cooling fan operation cycle time, and engine-driven units. Refer to the OEM service manual. OK Go To Next Step