Cummins — 4021389

B3.9, B4.5, B5.9 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-49 Intake Manifold Air Temperature Above Specification Cause Correction STEP 1 Charge air cooler fins, radiator fins, or air conditioner condenser fins are damaged or Inspect the charge air cooler, air conditioner condenser, and radiator fins. Clean, if necessary. Refer to Section 4 and the OEM service manual. ............. obstructed with debris OK Go To Next Step Open the cold weather radiator cover or the winterfront. Maintain a minimum of 387 cm 2 [60 in 2 ] of opening at all times. Refer to Section 1. STEP 2 Cold weather radiator cover or winterfront is closed .............

OK Go To Next Step STEP 3 Fan drive belt or water pump belt is broken ............. Check the fan drive belt and water pump belt. Replace the belts if necessary. Refer to Section A. OK Go To Next Step STEP 4 Fan shroud is damaged or missing or the air recirculation baffles are damaged or missing Inspect the shroud and the recirculation baffles. Repair, replace, or install, if necessary. Refer to the OEM service manual. ............. OK Go To Next Step STEP 5 Radiator shutters are not opening completely or Inspect the radiator shutters. Repair or replace if necessary. Refer to the manufacturer's instructions. Check the shutterstat setting. Refer to the OEM service manual.

the shutterstat setting is wrong ............. OK Go To Next Step STEP 6 Vehicle speed is too low for adequate cooling with high engine load ............. Reduce the engine load. Increase the engine (fan) rpm by downshifting. OK Go To Next Step STEP 7 Vehicle cooling system is not adequate ............. Verify that the engine and vehicle cooling systems are using the correct components. Refer to the OEM vehicle specifications. OK Go To Next Step STEP 8 Intake manifold temperature gauge is ............. Test the temperature gauge. Refer to the OEM service manual. malfunctioning, if equipped OK Go To Next Step STEP 9 Fan is not an adequate size for the application .............

Verify that the fan is the correct size. Refer to the engine and OEM vehicle specifications. OK Go To Next Step