Cummins — 4021389

Troubleshooting Symptoms Charts B3.9, B4.5, B5.9 Industrial Page TS-56 Section TS - Troubleshooting Symptoms Lubricating Oil Pressure Low Cause Correction Change the oil and filters. Refer to Procedure 007-002 (Lubricating Oil and Filters) in Section 5 . Use the oil recommended in Procedure 018-003 (Lubricating Oil Recommendations and Specifications in Section V. STEP 1 Lubricating oil does not meet specifications for ............. operating conditions OK Go To Next Step STEP 2 Lubricating oil is diluted with water ............. Check for a missing dipstick, rain caps, or oil fill caps. Change the oil. Refer to the OEM service manual.

OK Go To Next Step STEP 3 Lubricating oil filter is plugged ............. Change the oil and filter. Refer to Procedure 007-002 (Lubricating Oil and Filters) in Section 5 . Use the oil recommended in Procedure 018-003 (Lubricating Oil Recommendations and Specifications in Section V. OK Go To Next Step STEP 4 Lubricating oil is contaminated with coolant or fuel ............. Refer to the Lubricating Oil Contaminated symptom tree. OK Go To Next Step STEP 5 Lubricating oil leak (external) ............. Inspect the engine for external oil leaks. Tighten the capscrews, pipe plugs, and fittings. Replace gaskets, if necessary. Refer to a Cummins® Authorized Repair Location.

OK Go To Next Step Check the oil level. Add or drain oil, if necessary. Refer to Procedure 007-043 (Lubricating Oil Level) in Section 3. Use the oil recommended in Procedure 018-003 (Lubricating Oil Recommendations and Specifications) in Section V. STEP 6 Lubricating oil level is above or below specification ............. OK Go To Next Step STEP 7 Engine angularity during operation exceeds Refer to the Engine Data Sheet, the OEM service manual, or a Cummins® Authorized Repair Location. specification ............. OK Go To Next Step STEP 8 Lubricating oil pressure switch, gauge, or sensor is Check the oil pressure switch, gauge, or sensor for correct operation and location.

Refer to the OEM service manual. malfunctioning or is not in the correct location ............. OK Go To Next Step