Cummins — 4021389

B3.9, B4.5, B5.9 Industrial Fuel Recommendations and Specifications Section V - Maintenance Specifications Page V-9 Fuel Recommendations and Specifications Fuel Recommendations Do not mix gasoline, alcohol, or gasohol with diesel fuel. This mixture can cause an explosion. WARNING CAUTION Due to the precise tolerances of diesel injection systems, it is extremely important that the fuel be kept clean and free of dirt or water. Dirt or water in the system can cause severe damage to both the fuel pump and the fuel injectors. Cummins Inc. recommends the use of ASTM number 2D fuel. The use of number 2 diesel fuel will result in optimum engine performance.

At operating temperatures below 0°C [32°F], acceptable performance can be obtained by using blends of number 2D and number 1D. NOTE: Lighter fuels can reduce fuel economy. NOTE: Engines equipped with diesel particulate filters require the use of diesel fuel with 30 ppm sulfur maximum. There are no acceptable substitutes. The viscosity of the fuel must be kept above 1.3 cSt at 40°C [104°F] to provide adequate pumping and lubricating characteristics to fuel system components. The following chart lists acceptable substitute fuels for this engine. Additional information for fuel recommendations and specifications can be found in Fuel for Cummins Engines, Bulletin 3379001.

See ordering information in the back of this manual. Acceptable Substitute Fuels Number 1D Diesel(1) (2) (3) Number 2D Diesel(3) Number 1K Kerosene Jet-A Jet-A1 JP-5 JP-8 Jet-B JP-4 CITE A OK Not OK A A A A Not OK Not OK Not OK An "A" means OK only if fuel lubricity is adequate. This means the BOCLE number is 3100 or greater as measured by ASTM specification D6078, Scuffing Load Ball On Cylinder Evaluator (SLBOCLE). Lubricity can also be measured by ASTM, specification D6079, ISO 12156, High Frequency Reciprocating Rig (HFRR) in which the fuel must have a wear scar diameter of 0.45 mm [0.02 in] or less.

Any adjustment to compensate for reduced performance with a fuel system using alternate fuel is not warrantable. Winter blend fuels, such as found at commercial fuel-dispensing outlets, are combinations of number 1D and 2D diesel fuels and are acceptable.