Cummins — 4021389

Fan, Cooling B3.9, B4.5, B5.9 Industrial Page 3-2 Section 3 - Maintenance Procedures at Daily Interval Air Intake Piping Maintenance Check Inspect the intake piping daily for wear points and damage to piping, loose clamps, and punctures that can damage the engine. Replace damaged pipes and tighten loose clamps, as necessary, to prevent the air system from leaking. Check for corrosion under the clamps and hoses of the intake system piping. Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean, as required. Torque Value:

8 N•m [ 71 in-lb ] Air Tanks and Reservoirs Drain If automatic purging or spitter valves are used, confirm the valves are operating correctly. If a manual drain valve is used on the wet tank, open the draincock on the wet tank to drain any moisture accumulated in the air system. If oil is present, the air compressor system must be checked. Contact your Cummins Authorized Repair Location. Fan, Cooling Inspect for Reuse WARNING Do not rotate the engine by pulling or prying on the fan. The fan blade(s) can be damaged and cause the fan to fail and cause personal injury or property damage. Use the accessory drive shaft or the crankshaft barring tool to rotate the crankshaft.

A visual inspection of the cooling fan is required daily. Check for cracks, loose rivets, and bent or loose blades. Check the fan to make sure it is securely mounted. Tighten the capscrews, if necessary.