The alternator is maintenance-free, nevertheless, it must be above all, against moisture and water. Wiring protected against dust and, ° Diagram To Battery + ™~ ° —-—— a” Regulator fi aan RL = 150-250 OHM }o-¢—$H—-0 > Tote hH an EA803007 p Operate the alternator according to the instructions given in the chapter. 3.11.3. Starter motor The sliding-gear starter motor is flanged to the rear of the flywheel housing on the left-hand side. When the starting key switch is turned on, the starter motor pinion flies out and engages the ring gear of the flywheel. Then the main contact is closed, current flows, and the engine is started.
After the engine starts, the pinion automatically returns to its initial position when the starting key switch is released. Once the engine starts, the starting key switch should be released immediately. In case Otherwise, the starter motor may be damaged of repairing the engine dip the pinion of the starter and or burned out. ring gear into the fuel and remove the corrosion with brush. After that apply the grease on them to protect the corrosion. Whenever + you clean the starter, always pay attention entering the water. -~25- not to occur the electric short due to