SPECIFICATION FOR AUTOMOTIVE DIESEL FUEL (BV IV) (IS 1460-2005 with Amendment 2 March, 2010) SR. NO PARAMETER SPECIFICATION STD.METHOD Typical Analysis 1 Acidity, inorganic, mg KOH/g Nil IS 1448, P:2 Nil 2 Acidity, total, mg KOH/gm To report IS 1448, P:2 0.05 3 Ash, percent by mass, Max 0.01 IS 1448, P:4 /ISO 6245 4 Carbon residue (Ramsbottom) on 10% residue, % by mass, max 0.30 IS 1448, P:8 /ISO 10370 0.10 5 Cetane number, Min Cetane Index, min 51 46 IS 1448, P:9 /ISO 5165 ASTM D 4737/ISO 4264 53 55 6 Pour point, oC, Max 3oC, for winter 15oC, for summer IS 1448, P:10 /D5949 OR D 5985 OR D5950 -10 -10 7 Copper strip Corrosion for 3 hours @ 100oC Not worse than No.
1 IS 1448, P:15 /ISO 2160 No.1 8 Distillation, % v/v, recovered:
at 360oC, Min 95.0 IS 1448, P:18/ISO 3405 96.0 9 Flask Point (Abel) oC, Min 35 IS 1448, P:20 40 10 Kinematic Viscosity, Cst @ 40oC 2.0 to 4.5 IS 1448, P:25/ISO 3104 3.0 11 Total Contamination, mg/m3, Max 24 EN 12662 0.9 12 Density @ 15oC,kg/m3 820-845 IS 1448, P:16 OR P:32/ D 4052/ISO 3675 OR ISO 12185 825 13 Total Sulphur, mg/kg, Max 50 D 4298/P:34/ISO 20846 OR ISO 20847 OR ISO 20884/P:83/ D 5433/D 2622 / ISO 12937 40 14 Water content, mg/kg, Max 200 ISO 12937 150 15 Cold Filter Plugging Point (CFPP) oC, Max 6oC, for winter 18oC, for summer IS 1448, P:110 /D6371 -6.0 -6.0 16 Oxidation Stability, g/m3 25 Max ASTM D 2274 9.4 17 Polycyclic aromatic hydrocarbons (PAH), percent by mass, Max 11 IP 391 or EN 12916 1.0 18 Lubricity corrected wear scar diameter (wsd 1.4) at 60 oC, microns, Max 460 ISO 12156-1 420 19 Oxygen content, percent by mass, Max 0.6 Annex B NA Table 6.3 Winter:
November to February contains no Bio-Diesel. Refer IS 1460 2005 Specification with amendment No. 2 for further details. 48 48