3.4 VEHICLE HEALTH MONITORING SYSTEM VHMS – HEALTH MONITOR OPERATION Settings for Operator, Screen (No. 1.2.3), see illust. (Z 21576) When the button -Settings for Operator is pressed, the screen No. 1.2.3 is displayed. Entry of the Operator identification number (USER ID button): In the selection menu for settings (1.2.3) appears on the right side of the button ”USER ID” the actual eleven-digit Operator identifi- cation number. The use of the button ”USER ID” branches into the setting mode for the Operator identification number, see illust. (Z 21578). Without prior entry, 0 is predetermined as identification number.
To distinguish Operators, it is possible to enter a eleven-digit Operator identification number.To this effect, the Clear-button puts the cursor onto the first position (left side). Data entry may be started via the number buttons. If eleven numbers were entered each further entry will be ignored.Using the Enter-button the identification number will be taken over and branched back to the selection menu (1.2.3). Resetting the Truck Counter: Press the button ”Reset Truck Counter 1” the display changes to ”YES – NO” decision screen, picture (Z 21577). When pressing the ”YES” button the counter 1 will be reset to zero. Truck counter 2 is reset in the same way.
REMARK There are two hidden touch switches on the SETTING for Operator screen, see (1) and (2) illust. (Z 21576). These switches are used by service personnel for entering the Service Menu. To enter the Service Menu, first press the lower button (1) and then the upper button(2). 102