Komatsu — 3.7.1 STANDARD COMPONENTS IN CAB BASE

OPERATION 3.7 ELECTRICAL EQUIPMENT IN CAB BASE 3.7.1 STANDARD COMPONENTS IN CAB BASE REMARK On shovels with electrical pre-heating systems there are addi- tional components in the cab base. Refer to page 147 for more information. The cab base contains batteries which are located in a com- partment below the floor plate. Batteries emit highly explo- sive gas! Sparks or flame can cause the gas to explode. DO NOT smoke or use open flame when entering the cab base. DO NOT weld or grind near the batteries. DO NOT short across or ground any terminals of the batteries. On removal always disconnect the ground (-) cables first. when reinstalling the batteries connect the positive (+) cables first.

The cab base may contain high tension electrical appli- ances. Access to the cab base for authorized service staff only. All cables of the 24V DC board net system are of blue color. All other cable colors indicate a higher voltage: DO NOT touch these cables and their terminals and con- nected components. Always contact authorized Electri- cians having the permission to work on medium and high voltage systems. Legend for illustration Z 22579 (1) Cab base door. Keep the door always locked, access to the cab base for authorized personnel only. (2) Door handles (3) Lock rod for locking the cab base door in open position (4) Main switch board (X2), refer to page 137 for switch board components.

(5) Programmable logic controller (PLC) (6) Controller of the VHMS system (7) Electronic pump control module (MC7) (8) Back-up batteries for the programmable logic controller (PLC). The battery box is located below the floor plate. 135 WARNING WARNING WARNING WARNING