Komatsu — 3.7.3 COMPONENTS OF ELECTRICAL PRE-HEATING SYSTEM LOCATED IN THE CAB BASE

OPERATION 3.7 ELECTRICAL EQUIPMENT IN CAB BASE 3.7.3 COMPONENTS OF ELECTRICAL PRE-HEATING SYSTEM LOCATED IN THE CAB BASE The cab base contains high tension electrical appliances. Access to the cab base for authorized service staff only. General The preheating system is a special equipment and can be installed in the factory or locally at site. Power supply to the pre- heating system must be provided through an external power source. The following description applies to a typical preheating system as it is delivered ex works. The following systems are equipped with heaters:

Engine cooling system Engine lubricating system Hydraulic system (main and suction oil reservoir) PTO (pump distributor gear) Storage batteries REMARK The auxiliary heater unit in the cab base (6), illust. Z25358 and the battery charger (3) are also connected to the external power supply.

Legend for illustration Z25358 (1) Main switch board (1X1) for the preheating systems, located in the cab base (2) Main switch (1Q1) for all system heaters (3) Battery charger (E55) (4) Fuse box with circuit breaker F76 - 125A for battery charger (5) Key switch (S153) for battery charger (3) (6) Heater unit for cab base Be sure to switch off main switch (2) and to disconnect power supply cable before working on any part of the heating system. 147 WARNING WARNING WARNING WARNING