4.6 LUBRICATION AND MAINTENANCE SCHEDULE MAINTENANCE (1) Perform maintenance according to separate Engine Operation an Maintenance Manual filed in volume 2 binder. (2) Perform inspections according to the separate Manual ”FIRE SUPPRESSION SYSTEM” filed in volume 2 binder. (3) Perform inspections according to the separate Manual ”OPERATING INSTRUCTIONS AC” filed in volume 2 binder. (4) Perform maintenance according to separate Service Bulletin "Eliminator Filter" filed in volume 2 binder. Carry out initial service according to item 4.6.1.
246 Service Intervals Service Point Service See Every 1000 operating hours or every 6 months High strength bolt connections Check for correct tightening torque and security page 325 Hydraulic system Replace return and pressure fil- ter elements Clean or replace high pressure filter elements Replace breather filter elements Drain sediments page 367 PTO (Pump distributor gear) Swing machinery and Travel gears Oil sample analysis page 379 Signal horn compressor Clean and lubricate page 381 Hydraulic track tensioning system Check pressure accumulators page 383 Water filter for hand wash sink in Operator’s cab Replace carbon filter cartridge page 385 Hydraulic oil cooler doors and machinery house doors Inspect and lubricate door hinges page 387 Engine Maintenance (1) Fire suppression system Maintenance (2) Air conditioning Inspect the complete system (3) Eliminator filter Maintenance check (4) CAUTION CAUTION