RT115 Tier 2 - BACKHOE ATTACHMENT 141 1. Move attachment speed/direction control to neutral position. 6. Check that backfill blade is straight and lower it to ground. NOTICE: Engine speed affects speed of backhoe operation. 5. Lower rear attachment to 6” (150 mm) above ground. 3. Move ground drive control to neutral position. 7. Decrease engine speed to low throttle. 9. Lower stabilizers enough to lift front tires. 8. Move to backhoe operator’s station. 10. Remove swing lock pin from hole (1) and store in hole (2). 13. Adjust engine speed to 1/2 to 3/4 throttle for digging. 4. Shift gearbox control to 1 (low). 11. Raise boom to release tension on stow lock. 12.
Release stow lock by pushing handle forward. 2. Apply service brake. p SETUP SETUP