RT115 Tier 2 - DRILLING ATTACHMENT 151 After drill bit enters target trench, the bore hole may be enlarged by changing the drill bit to a backreamer and drawing it back through the initial bore. 2. Back up tractor 6" (150 mm) to loosen drill rod in ground. IMPORTANT: Always rotate clockwise during backreaming. Rotate counterclockwise only to dislodge a dry bore bit or reamer that has siezed in the bore hole. Do not try to increase hole size too much in one pass. Several passes using successively larger reamers will save wear on machine. During backreaming, keep drill string straight. Sharp bends in the drill rod at the motor coupling can cause rod failure. 5.
When backreamer exits the bore hole, stop rotation immediately. 3. Start tractor engine and begin clockwise rotation. 4. Slowly back up tractor while maintaining rotation. 3. Disconnect drill rod from drilling attachment. 5. Add one drill rod to continue bore. 1. Turn tractor ignition switch to STOP. 2. Replace drill bit with backreamer. 4. Move tractor away from bore. 1. Stop drilling attachment. p ADD ROD BACKREAM IMPORTANT: ADD ROD