96 RT115 Tier 2 - TRENCHER ATTACHMENT OPERATING TIPS Avoid using badly worn teeth. When replacing teeth, maintain original pattern. Use Ditch Witch replacement teeth. If an object becomes lodged in chain, move attachment speed/direction control to neutral and raise boom slightly. Reverse chain direction. If object must be removed manually, turn engine off and engage parking brake. When cutting asphalt, start trench in soil at edge of road and use shortest possible boom at full depth. Always start trenching with ground drive speed set at low. If soil conditions permit optimum digging at higher ground drive speed, select high.
Before operating booms equipped with rock chains, check bits for free rotation. Tap bits lightly with a hammer and turn by hand. If bits are stuck, remove and clean packed soil from bit block. Carbide bits are recommended for cutting abrasive material, such as sandstone or frozen sands, gravels or asphalts. Sight along center of hood to a stake driven beyond end of trench line for straight trench. Use correct length boom. See your Ditch Witch dealer for more information. Do not make sharp turns. Lower boom to full depth when turning. EMERGENCY SHUTDOWN - Turn ignition switch to STOP. Operate engine at full throttle when working. p OPERATING TIPS