John Deere 326D, 328D, 332D — Check and Drain Auxiliary Fuel Filter and Water Separator—If Equipped

Maintenance—Every 10 Hours or Daily Check Coolant Level CAUTION: Prevent possible injury from hot spraying water. Shut off engine. Remove filler cap only when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. TX1065510A —UN—02OCT09 Check coolant level by viewing coolant in overflow tank (2) when engine is cold. 1. Park machine. 2. Allow engine to cool. 3. Open engine cover. 4. Check overflow tank for coolant level. Coolant should be above the MIN COLD line (3), but below the MAX COLD line (4). 1— Radiator Cap 2— Overflow Tank 3— MIN COLD Line 4— MAX COLD Line 5.

If coolant is below the MIN COLD line, add coolant to the overflow tank. For recommended coolant, see Maintenance—Machine. (Section 3-1.) 7. Allow engine to cool and check coolant level again on overflow tank. 8. If level is still low on overflow tank, repeat procedure as necessary. 6. Close engine cover and run engine. OUT4001,00004BA -19-21FEB13-1/1 Check and Drain Water Separator Fuel Filter 1. Park machine. 2. Open engine cover and remove left engine side panel. 3. Place a suitable container under drain valve (2) of water separator fuel filter (1). 4. Loosen drain valve to drain water and sediment into container. Dispose of waste properly. 5. Tighten drain valve. 6.

Install left engine side panel. 7. Close engine cover. TX1065525A —UN—10OCT09 1— Water Separator Fuel Filter 2— Drain Valve OUT4001,00004BB -19-09OCT09-1/1 3-4-2 071713 PN=112