Maintenance—Initial Service - 250 Hours Change Engine Oil and Replace Filter NOTE: Replace filter and change oil initially at 250 hours, then every 500 hours thereafter when using John Deere filter and PLUS-50™II oil. TX1065666A —UN—06OCT09 1. Park machine. 2. Run engine a few minutes to warm oil. 3. Engage park brake and stop engine. 4. On right side of machine, remove two outer cap screws (2) from access cover (1) and pull out cover with attached engine oil drain hose. 5. Place suitable container under hose plug (3). Remove hose plug using two wrenches to avoid twisting hose. Allow oil to drain into container. Dispose of waste oil properly. TX1065667A —UN—10NOV09 NOTE:
Make sure O-ring is still intact when installing hose plug. 6. After oil is drained, install hose plug. 7. Open engine cover and remove right engine side panel. 8. Clean dirt or debris from around engine oil filter (4). 9. Place suitable container under drip tray below the engine oil filter. 10. To remove oil filter, turn filter counterclockwise using a filter wrench. TX1065671A —UN—06OCT09 11. Allow excess oil to drain into container. Dispose of old filter and waste oil properly. 12. Apply a film of clean engine oil on seal of new filter. 13. Install filter. Turn filter until seal contacts mounting surface. Then turn filter by hand 2/3 to 1 turn more.
1— Access Cover 2— Cap Screw (2 used) 3— Hose Plug 4— Engine Oil Filter PLUS-50 is a trademark of Deere & Company Continued on next page OUT4001,00004E2 -19-10NOV09-1/2 3-6-1 071713 PN=115