John Deere 326D, 328D, 332D — Replace Primary Engine Air Filter

Maintenance—Every 500 Hours Replace Primary Engine Air Filter IMPORTANT: Prevent possible engine damage. Do not clean primary engine air filter. Replace it when air restriction light is illuminated on engagement and monitor unit (EMU). To prevent dirt from being sucked into engine, do not remove filter when engine is running. TX1086260A —UN—27DEC10 Do not start engine without both the primary and secondary filters installed. 1. Park machine. 2. Raise boom and lock in raised position. Service Cover Latches and Dust Unloader Valve 3. Stop engine and engage park brake. 4. Open engine cover and remove left engine side panel. 5.

Remove the dust unloader valve (3) and clean out any dust found in the drop tube. TX1065986A —UN—13OCT09 6. Install dust unloader valve or replace if found worn or damaged. 7. Unlatch service cover latches (1) and remove service cover. 8. To remove the primary filter (2), gently move the end of the filter back and forth to break the seal. Primary Filter 9. Gently pull the filter out of housing and discard. Avoid dislodging contaminant from the filter or knocking it against the housing. 10. Remove the secondary filter (4) by pulling it straight out. TX1086639A —UN—06JAN11 11. Inspect the seal surface and housing for any damage. Replace the complete air cleaner if damage is present. 12.

Block the outlet tube of the air cleaner using a small dampened towel prior to proceeding with cleaning the seal surface to avoid contaminating the induction system. Secondary Filter 13. With a second small dampened towel, thoroughly clean the inside surface of the housing and seal areas. Be careful not to introduce contaminant into the outlet tube. 1— Service Cover Latch (3 used) 2— Primary Filter 3— Dust Unloader Valve 4— Secondary Filter 14. Inspect the new primary filter carefully. Check for any voids, cuts, tears, or indentations in the urethane-sealing surfaces. complete a tight seal. Continue pushing the filter into the outlet tube until it stops.

The critical sealing area will compress slightly, adjust itself, and distribute the sealing pressure evenly. 15. Remove the dampened towel from the outlet tube that was used to protect the induction system during servicing. 16. Install the secondary filter by pressing it firmly in place until seated. When properly fitted it should fit snugly inside the outlet tube. IMPORTANT: Prevent possible engine damage. If the service cover does not fit flush to the body, the primary filter is not properly seated in the housing. Check the primary and secondary filter installation, following the proper installation procedure so they become fully seated. The service cover will then go on easily.

Using the service cover to push the filters could cause damage to the housing and will void the warranty. 17. Install the new primary filter by gently sliding it over the secondary filter and pressing it in place until fully seated. When installing, apply pressure by hand at the outer rim of the filter, not in the center, to Continued on next page MB60223,0000227 -19-09NOV12-1/2 3-8-4 071713 PN=121