John Deere 326D, 328D, 332D — Monthly Storage Procedure

Miscellaneous—Machine Storage Prepare Machine for Storage IMPORTANT: Avoid machine damage, do not use biodiesel during machine storage. When using biodiesel blends, switch to petroleum diesel for long term storage. 1. Before storage, operate engine on at least one complete tank of petroleum diesel fuel to purge the fuel system. Ensure that the fuel tank is full during storage to prevent water buildup due to condensation. T5813AM —UN—09FEB89 NOTE: For blends up to and including B20, it is recommended that biodiesel be used within three months of its manufacture. For blends greater than B20, it is recommended that the biodiesel be used within 45 days.

The poor oxidation stability characteristic of biodiesel can result in long-term storage problems. John Deere does not recommend using biodiesel in engines powering standby applications or vehicles operating on a seasonal basis. Consult your John Deere dealer or fuel supplier for additives to improve fuel storage and performance of biodiesel fuels. These additives must be added to the biodiesel close to its time of production for them to be effective. Prepare Machine for Storage 5. If possible, raise machine high enough so tires do not touch the ground. If not, park on a hard surface to prevent tires from freezing to ground. 6. Store machine in a dry, protected place.

If stored outside, cover with a waterproof material. IMPORTANT: LPS 3 Rust Inhibitor can destroy painted finish. DO NOT spray LPS 3 Rust Inhibitor on painted areas. 2. Repair worn or damaged parts. Install new parts, if necessary, to avoid needless delays later. 7. Retract all hydraulic cylinders, if possible. If not, coat exposed cylinder rods with LPS ® 3 Rust Inhibitor. 3. Replace air cleaner elements. 8. Place a DO NOT OPERATE tag on the right control lever. IMPORTANT: High pressure washing greater than 1379 kPa (13.8 bar) (200 psi) can damage freshly painted finishes.

Paint should be allowed to air dry for 30 days minimum after receipt of machine before cleaning parts or machines with high pressure. Use low pressure wash operations until 30 days have elapsed. 9. Lubricate all grease points. 10. Remove the battery and store in a dry, protected place after charging fully. If not removed, disconnect the negative battery cable from the (—) terminal. 11. Drain water separator fuel filter. 4. Wash the machine. Use low pressure wash operations (less than 1379 kPa (13.8 bar) (200 psi) until 30 days after receipt of machine have elapsed. Paint areas to prevent rust. Replace decals, where needed. 12. Remove keys and lock engine cover and door, if equipped.

LPS is a trademark of the Holt Lloyd Corporation. OUT4001,00004E9 -19-12NOV12-1/1 4-4-1 071713 PN=159