John Deere 326D, 328D, 332D — Chain Case Oil

Maintenance—Machine Testing Diesel Engine Coolant Maintaining adequate concentrations of glycol and inhibiting additives in the coolant is critical to protect the engine and cooling system against freezing, corrosion, and cylinder liner erosion and pitting. Add only the recommended concentration of John Deere COOL-GARD II Coolant Extender. DO NOT add more than the recommended amount. When Using Nitrite-Containing Coolants Test the coolant solution at intervals of 12 months or less and whenever excessive coolant is lost through leaks or overheating.

Compare the test strip results to the supplemental coolant additive (SCA) chart to determine the amount of inhibiting additives in your coolant and whether more John Deere Liquid Coolant Conditioner should be added. Coolant Test Strips Coolant test strips are available from your John Deere dealer. These test strips provide a simple, effective method to check the freeze point and additive levels of your engine coolant. Add only the recommended concentration of John Deere Liquid Coolant Conditioner. DO NOT add more than the recommended amount.

When Using John Deere COOL-GARD II Coolant Analysis John Deere COOL-GARD II Premix™, COOL-GARD II PG Premix and COOL-GARD II Concentrate are maintenance free coolants for up to six years or 6000 hours of operation, provided that the cooling system is topped off using only John Deere COOL-GARD II Premix or COOL-GARD II PG premix. Test the coolant condition annually with coolant test strips designed for use with John Deere COOL-GARD II coolants. If the test strip chart indicates that additive is required, add John Deere COOL-GARD II Coolant Extender as directed. For a more thorough evaluation of your coolant, perform a coolant analysis.

The coolant analysis can provide critical data such as freezing point, antifreeze level, pH, alkalinity, nitrite content (cavitation control additive), molybdate content (rust inhibitor additive), silicate content, corrosion metals, and visual assessment. Contact your John Deere dealer for more information on coolant analysis. COOL-GARD is a trademark of Deere & Company DX,COOL9 -19-11APR11-1/1 Hydraulic and Hydrostatic Oil 50˚C 122˚F Use oil viscosity based on the expected air temperature range during the period between oil changes. 40˚C 104˚F Your machine was shipped from the factory with engine oil in the hydraulic system.

Engine oil has been tested to be compatible with high quality anti wear hydraulic oils (AWHO). There is no risk to the hydraulic system of using a high quality AWHO meeting the system oil specifications to top off the system, or for future oil changes. SAE 15W-40 SAE 10W-40 30˚C 86˚F SAE 10W-30 SAE 0W-40 20˚C 68˚F SAE 5W-30 SAE 10W PREMIUM AW32 10˚C 50˚F The following oil is preferred: John Deere PLUS-50™II 0˚C 32˚F -10˚C 14˚F The following oil is also recommended: John Deere TORQ-GARD SUPREME™ -20˚C -4˚F TX1079469 —UN—06JUL10 Other oils may be used if they meet one or more of the following:

API Service Classification CH-4 or better -30˚C -22˚F -40˚C -40˚F Hydraulic and Hydrostatic Oil PLUS-50 is a trademark of Deere & Company TORQ-GARD SUPREME is a trademark of Deere & Company MB60223,000023C -19-12NOV12-1/1 3-1-15 071713 PN=95