Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION OPERATION OPERATION seat to the right for the ease of USING SEAT BELT WARNING brake pedal fully, and adjust the tether belt (1). Tense tongue (4) connected to wind-in clicks. The belt is pulled (2) until it is fitted to your under this condition and cannot belt to your abdomen without then repeat the above procedure from the start. 5. Pull the belt to check that it is securely locked in position. 6. When removing the belt, press the red button on buckle (3). The belt will automatically retract. 3 - 90 (D) Adjusting direction of seat Pul l up lever (5) to unlock the seat ° to the right. Aft er changing the direction of the loc k the seat.

Change the direction of the s operation of the ripper. Before fastening the seat belt, insp ect the securing brackets and belt for Replace any worn or damaged sea Even no problem can be seen with the belt, always replace the seatbelt once every three years. The date of manufacture is g iven on the rear side of the belt. ore operating the machine. rating the machine. thout twisting. Adjust and fasten the seat belt bef Always use the seat belt when ope F it the seat belt across your lap wi Check that the bolts of the clamp securing the belt to the chassis are not loose.

Tighten t Th e tightening torque for the mou nting bolt is 24.5 ± 4.9 Nm (2.5 ± 0.5 kgm, 18.1 ± 3.6 lbf If th e belt surface is scratched or frayed or if the fittings are broken or deformed, replace t FASTEN THE BELT AND REMOVE IT 1. 2. 3. 4. Sit on the seat, depress the seat so that your back is pres After adjusting the seat positi the tether belt and install it wh seat. Sit on the seat and hold to mechanism (2) and pull out th cover your abdomen sufficien Insert tongue (4) in buckle (3 back into wind-in mechanis abdomen. The belt is locked be extended anymore. Fit th twisting it. REMARK If th e belt is locked before the ton it r