Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER 3 - 120 When adjustin g, it is dangerous if the work equi pment is moved by mistake. Set the work e quipment in a saf e condition, the n stop the engine an d lock the work equipment secure ly with the work equipment loc NOTICE tilt is 750 mm (29.6 in)for the EX specification machine and 500 mm (19.7 in)for the PX specification machine.

The maximum tilt is 750 mm (29.6 in)for the EX specification machine and 500 mm (19.7 i n)for the PX specification machi When tilting, make sure that it does not exceed 750 mm (29.6 in)for the EX specification machine or 500 m m (19.7 in)for the PX specification machine. m tilt is exceeded, excessive force will be brought to bear on all parts, and this will damage the machine. If the maximu m tilt is exceeded, excessive forc e will be brought to bear on all p arts, and this will d amage t If the blade control lever is operated, the f be obtained. Right side: 4 Left side: 41 If more tilt is Use bar han dle (2) installed to the left bra change leng th (L) of the brace.

This make s it possible to obtain maximum tilt of 750 mm (29.6 in) for the E and 500 mm (19.7 in) for the PX specificat Standard distance between joints (L): 1 ADJUSTING SHIM IN BLADE CYLINDER CA Set the stan dard shim adjustment in the bla (0.16 in). Remove shi ms to balance the wear of the end of the pi The proper c learance to be maintained wit mm (0.008 t