. OPERATION OPERATION ADJUSTING BRACE WARNING again according to the procedure given above. 1. Remove shim (1) and tighten bolts (2) to eliminate the ball joint play. 2. Measure clearance "A" and remove bolts (2). 3. Adjust the thickness of shim (1) to (A + 0.5) - (A + 1) mm, then tighten bolt (2). 4. Confirm that ball joint can move smoothly after tightening bolts. 3 - 122 If maintenance is carried out with t he engine running, always have one worker s itting in the operator' s seat while another worke carries out the maintenance. Both workers must mutually confirm the safety du ring the operation.
Start the engine, then use fine operation of the blade control lever to tilt to the left and right. M ove the blade up and down while rotating the brace handle. Th easier. is makes the adjustment operation When extending the brace It is easy to carry out the adjus tment if the blade is set on top of a block and the brace handle is turned. REMARK When operated in this way, the blade is tilted, so the handle gradually becomes heavier. W from the tilt position to the hori hen this happens, return the blade zontal position and turn the handle SHIM ADJUSTMENT Adjust the thickness of shim s o that the ball joint play (6 points) in the axial direction (shown by (0.04 in).
the arrow) does not exceed 1 mm