Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING ° or less. ramps. In addition, and the machine is When loading or unloading, always use ramps or a platform. Proceed as follows. the trailer and put blocks under ° . 3 - 132 Since loading and unloading of the machine is dangerous, be extremely careful. When loading or unloading the ma chine, operate it slowly with the engine speed low and the transm Use ramps having sufficient width, length, thickness, and strength. Install them securely and set the If the ramps are deflected apprecia bly, reinforce them with blocks. Perform the loading work of the ma chine on firm, level ground. Secure sufficient distance between the the trailer.

Remove mud from the undercarria ge of the machine so that the machine will not slip sideways on remove water, snow, ice, grease, o il, etc. from the ramps. Never steer the machine on the ra mps, since steering on the ramps can cause the machine to tip o change the travel direction, return to the ground or to the bed of the trailer, then change the travel di The center of gravity of the mac hine shifts suddenly at the border unbalanced and becomes dangero LOADING 1. 2. 1. Load and unload on firm level Maintain a safe distance from 2. Properly apply the brakes on the tires to ensure that the tra Make the slope of the ramps 3. Start the engine. Warm the engine up fully. FREE position (F). 4.

Set parking brake lever to the 5. Set the transmission in the 1s idle. t gear and run the engine at low 6. Set the travel direction toward the ramps and drive slowly. 7. The center of gravity of the machine shifts suddenly at the border between the ramps unbalanced and becomes da border slowly. and trailer, and the machine is ngerous. Accordingly, pass the ified position on the trailer. 8. Stop the machine at the spec