. MAINTENANCE GUIDES TO MAINTENANCE 4 - 3 DUSTY WORKSITES: es, do as follows: ore frequently to see if the air cleaner is clogged. nt at a shorter interval than specified. an air cleaner clogging monitor, the check can be carried out with the monitor. uently to avoid clogging. ilter frequently. s, especially the starting motor and alternator, to avoid accumulation of dust. When working at dusty worksit Inspect the dust indicator m ore frequently to see if the air cleaner is clogg Clean the air cleaner eleme nt at a shorter interval than specified.
On machines equipped with an air cleaner clogging monitor, the check ca n be carried o ut with the m Clean the radiator core freq Clean and replace the fuel f Clean electrical component s, especially the starting motor and alternator, to avoid accumulation of d When inspecting or changin g the oil, move the machine to a place that is f ree of dust to prevent dirt fr om getting into the oil. AVOID MIXING OILS: If a different brand or grade of o il has to be added, drain the old oil and replace all the oil with the new bra nd or grade of oil. Never mix different bran d or grade of oil. PRECAUTIONS WHEN OPENING AND CLOSING ENGINE SIDE COVER:
When standing on track to open the engine side cover, adopt a standing position, hold the side cover with both thumbs, and open it slowly with your other fingers. When standing on track to o LOCKING INSPECTION COVER S: ly into position with the lock bar. If inspection or maintenance is performed with Lock inspection cover secure inspection cover not locked in position, there is a danger that it may be sudd enly blow shu t by the wind and cause injury to the worker. BLEEDING AIR: When hydraulic equipment ha s been repaired or replaced, or the hydraulic p iping has bee n removed an d installed again, the air must be bled fro 4-43)". m the circuit.
For details, see "BLEEDING AIR IN HYDRAULIC SYSTEM (PAGE PRECAUTIONS WHEN INSTAL LING HYDRAULIC HOSES: ations where there are O-rings or gasket seals, clean the mounting surface, and not to forget to assemble the O-rings and gaskets. When removing parts at loc replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gas When installing the hoses, d o not twist them or bend them sharply. If they are installed so, their serv ice life will be shortened extremely and they may be damaged.