. MAINTENANCE OUTLINES OF SERVICE 4 - 6 COOLANT AND WATER FOR DILU TION n of preventing corrosion as well as preventing freezing. ot an issue, the use of antifreeze coolant is essential. The coolant has the important functio n of preventing corrosion as well as preventing freezing Even in the areas where freezing is n Komatsu machines are supplied with excellent anticorrosion, antifreeze an As a basic rule, we do not recomm (AF-NAC). If you use another coolan of the cooling system that use light m ot an issue, the use of antifreeze coolant is essential. Komatsu Supercoolant (AF-NAC).
Komatsu Supercool ant (AF-NAC ) has d cooling propertiesand can be used continuously for 2 ye ars or 4000 h ours. end the use of any coolant other than Komatsu gen uine supercoolant t, it may cause serious problems such as corrosion of th e engine and parts etals such as aluminum. use distilled water or tap water (soft water). or well water (hard water), contains large amounts of minerals (calcium, When diluting the antifreeze coolant, Natural water, such as a river water magnesium, etc.), and this makes it e inside the engine or radiator, it is e exchange, so when you dilute the co than 100 PPM. asier for scale to form inside the engine or radiator.
Once scale is deposited xtremely difficult to remove. It also causes overheating due to poor heat olant, we recommend that you use water with an overa ll hardness of less rve the precautions given in the Operation and Maintenance Manual. e sure to keep it away from flame. to water differs according to the ambient temperature. see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-20)". When using antifreeze, always obse rve the precautions given in the Operation and Maintena nce Manual.
Antifreeze coolant is flammable, so b The ratio of Supercoolant (AF-NAC) For details of the ratio when mixing, Even in areas where it is not necess least 30% to prevent corrosion of the Supercoolant (AF-NAC) may be sup see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4 ary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at cooling system. plied in premix. In this case, never add diluting water. ngine to cool before adding coolant. If the engine overheats, wait for the e If the coolant level is low, it will cause overheating, and will also cause problems with corrosion due to air entering the coolant. GREASE d noises at the joints. under heavy-duty conditions.
Always use the recommended grease and Grease is used to prevent seizure an This construction equipment is used follow the change intervals and reco Manual. mmended ambient temperatures given in this Operation and Maintenance The nipples not included in the MAIN TENANCE section are nipples used when overhauling, s o they do not need grease. If any part becomes stiff or generate s noise after being used for a long time, grease it. that is pushed out when greasing. Always wipe off all of the old grease Be particularly careful to wipe off the wear of the rotating parts.
old grease in places where sand or dirt sticking in the gr ease would c ause CARRYING OUT KOWA (Komatsu Oil Wear Analysis) KOWA is a maintenance service that m akes it possible to prevent machine failures and downtim e. With KOWA , the oil is periodically sampled and analyzed . This enables early detection of wear of the machine dri ve parts and other problems. We strongly recommend you to use this service. The oil analysis is carried out at actual cost, so t he cost is low , and the results of the analysis are reported t ogether with recommendations which will reduce repair costs and machine downtime.