Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE SERVICE PROCEDURE CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING outer element. NOTICE INSPECTION FOR MACHINES EQUIPPED WITH AIR CLEANER CLOGGING MONITOR monitor (1) of the monitor panel flashes, NOTICE 4 - 24 Always wear prot ective glasses, dust mask , or other protecti ve equipment. When removing th e air cleaner element fro m the air c leaner b ody, i t is dangerous to pull it out by fo When working at high places or where the f oothold is poor, b e careful not to fall because of the reac tion when pulling out the CHECKING If the internal yello w piston overlaps the red zone on the outside If t diameter of dust in dicator (1), clean the a ir cleane r eleme nt.

After cleaning, pre ss the reset button to r eset the piston. Always wait for the y zone on the outside ellow piston in the dust before cleaning the elem indicator to overlap the red ent. e yellow piston in the dust If t he element is cle aned frequently before th iston in ust indicator overlaps t he red zone on the outs ide, the a ir clean er will be unable to display it become poor. s normal performance and the cleaning effect will will In addition, the frequ ency of dust stuck to th e element falling i nside the inner element during the cleaning operation w ill increas e.

(If equipped) air cleaner clog If clean the air clean Do not clean the air c leaner element until the air cleaner cloggin g monitor on the monitor pane l flashes. If the element i s cleaned frequen tly before the clogging monitor flashes, the air cleaner w ill not be able to d isplay its performance fully, an d the cleaning efficiency will also g o down In addition, during th e cleaning operation, mo re dirt stu ck to th e element wil l fall inside the inn