. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUST TRACK TENSION transmission in adjust it in the ADJUSTMENT WARNING pressure. Grease one turn. Do not Komatsu distributor. 4 - 28 The wear of pin s and bushings on the undercarria ge will vary with th e working conditions and types of soil. It is thus necessary to co ntinually inspect the track tension so as to maintain the standard tension. Carry out the c heck and adjustment under the s ame conditions as becomes clogg ed with mud, measure with the tra INSPECTION ne on level ground (stop with the Stop the machi FORWARD wit hout applying the brake).
Then pla on the track sho es between the carrier roller and th in the figure, an d measure the clearance between grouser at the m idpoint. If the clearance (A) is 20 to 1.18 in), the t ension is standard. sion is not at the standard value er. If the track ten following mann Grease inside ad justing mechanism is under high coming from lubri cator (1) under pressure can penetrate injury or death. For this reason, d o not loosen lubricator (1) more than loosen any part o ther than lubricator (1). Furthermore, d of your body in fr ont of the grease fitting. If the track tensio n is not relieved by this procedure, pl Komatsu distribut or.
WHEN INCREASI ase through grease fitting with a at the correct tension has been ac hieved, move the machine backwards an rack tension again, and if the tens ion is not correct, pump in grease until (S) becom ill loose, the pin and bushing are e t be either turned or replaced. Ple