. MAINTENANCE SERVICE PROCEDURE 1. Bleeding air from cylinders Fuel control (1 place) 4 - 43 BLEEDING AIR IN HYDRAULIC SYS See " OPERATIONS AND CHECKS AFTER STARTING ENGINE (PAGE 3- Since the engine must be started a nd the blade must be operated, see OP NOTIC If the e ngine is run at high speed immedi ately after startup or a cylinder is pushed up to its stroke en d, air tak en inside the cylinder may c ause damage to the piston packin 1) Run the engine at low idle, and extend and retract each cylinder 4 to 5 times, ta king ca re that a cylinde r is not moved to the end of its stroke. (Stop the cylinder approx.
100 m m (3.9 in) s hort of i ts stroke end) 2) Next, operate each cylinder 3 to 4 times to the end of its stroke. 3) Finally, operate each cylind er 4 to 5 times to the end of its stroke to completely remove the air. CHECK ELECTRICAL INTAKE AIR H Chec k before the cold season start Remove the electric heater from th e engine intake manifold and check for w ire disconnections and dirt clinging to it When checking and installing the el ectric heater, replace its gasket with a n LUBRICATING e ground, then stop the engine. 1. L ower the work equipment to th 2. U sing a grease pump, pump in grease through the grease fittings shown by arrows 3.
A fter greasing, wipe off any old grease that was pushed out.