Komatsu — CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST

. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST CHECKING mm 4 - 47 The (0.5 1 to 0.63 in) when pressed by th umb (appro x 99.1N {10 a point midway between the drive p ulley and al ternator pull ADJUSTING 1. 2. 1. Loosen bolt s (1) and nuts (2), (4 ), and (5), th en turn nut ( adjust the b elt tension. 2. After adjusti ng, tighten bolts and nuts (2), (4) , and (5), to s alternator (3 ) in position. REMARK Check each pulley for breakage and wear of the V-groove . In particular, check that the V -belt does not touch the bottom of the V-groove If any abnor mality is found, ask your Komat su distributor for replacement of the pulley.

If the V-belt i s so lengthened th at it cannot b e adjusted a ny more or if it has any cuts or When adjust ing the V-belt, do n ot press the alternator dir ectly with a bar, but put a woo d piece, etc. in-between them. If the V-belt h as been replaced w ith a new pa rt, there will be initial elongation, so inspect and adjust it again after one-hour of o peration.