. OPERATION EXPLANATION OF COMPONENTS 3 - 31 METHOD OF USING USER ADJUST MODE Wit h the user adju st mode, the brightness o f the panel scree n backlightin g and t he contras t of the li quid crystal pane can be changed, or the cooling fan can be set to maximum speed to clean the radiator w hen it is These are display 1. Adjusting bac klighting of liquid crystal display mode for adjusting the 1) The diagr brightness This displ adjustmen is turned t 1) The diagr am on the right is the he of the backlighting of th e liquid crystal p anel . ay will be switched to the screen brightness t display, if the alarm bu o the U position.
zzer cancellation switch 2) The brigh tness can be adjusted by operating the n switch. he informatio The highe the lower t > position: r the number, the bright er the screen becomes; he number, the darker t Number increases he screen becomes. 3) The bright ness of the backlight for the LCD gauges may be held cons switch to t tant by turning the ala he U position. rm buzzer cancellation REMARK maintenance mode, operate the buzzer cancel switch to t. T o return to the maintenance mode, op erate the buzzer cancel switc h to t T he brightnes s of the backlighting of t he monitor panel differs according t o whether t he front lamp is lit o r not.
E a b ntering this m ode when the front lamp s are lit makes it possible t o a djust the brightness whe n the front l amps re lit. In the s ame way, entering this mode when the front lamps are not lit makes it possible to adjust the t lit. the fron rightness whe n the front lamps are no