. OPERATION EXPLANATION OF COMPONENTS CIRCUIT BREAKER If the starting switch does not work even when the starting switch is turned to the ON position, open the recirculated air filter cover to gain access to the circuit breaker. If excessive current flows through the circuit breaker, it cuts off the electric circuit to prevent damage to the electrical components and wiring. To restore the electric circuit after it has been cut off, push in reset button (3). (This springs out when the circuit is cut off.) If the electric circuit is normal, reset button (3) will stay pushed in. If it comes out immediately when it is pushed in, the electric circuit must be checked.
Circuit breakers (1) and (2) also act as reset button (3). REMARK The circuit breaker is a device installed in electric circuits where a large current flows. It is installed to protect the electric circuit. It protects the electric components and wiring from damage caused by an abnormal current in the same way as a normal fuse. After repairing and restoring the location of the abnormality, there is no need to replace the breaker. It can be used again. 3 - 47 MAIN POWER CIRCUIT BREAKER If the starting motor i s not actuated e switch is turned to the ON position, open the batte ry cove r at rear le ft side of the mac hine, and inspect circuit bre akers (1) (2).
Circui t breakers (1) an d (2) also act as t he reset button. If ther e is a surge of current, the circui t breaker shuts off circuit dama Turn t break When resetting the ele ctrical circuit after i t has bee n shut off, press th e reset button 5 to 10 mi nutes after the circuit has b een shut off. Wh en the electrical c ircuit has been s hut off, the operation of the reset b utton is heavier than when the circuit is norm al. The height of the reset button is t he sam e, regardless of whethe r the circuit has been shut o ff or has been re set, so make not e of the ef fort of the reset b utton when resetting the Do no t keep the circuit breaker reset bu tton longe r than necessary.
If the ircu distrib No Fuse capacity Circuit (1) 105A General power supply (2) 30A Permanent power supply for cab No Fuse capacity Circuit (1) 20A Starting switch (2) 20A Air conditioner