. OPERATION OPERATION CHECK ELECTRIC WIRING WARNING CHECK FLASHING OF LAMPS, CHECK FOR DIRT AND DAMAGE 17.5R25TG A 300 {3.00, 42.6} Tire size Inflation pressure: kPa{kg/cm 2 , PSI} 14.00-24-14PR 300 {3.00, 42.6} 14.00R24TG A 400 {4.00, 56.8} CHECK CONDITION OF WINDOW WASHER SPRAY Operate the window washer and check that the washer fluid is sprayed out properly. If the fluid does not spray out properly, clean the washer nozzle with a safety pin or thin wire. If the condition is still not improved, please ask your Komatsu distributor to carry out inspection and repair. CHECK WIPING EFFICIENCY OF WIPER Operate the wiper and check that it wipes the window properly under each operating speed:
Intermittent, low speed, high speed. Operate the window washer to make the glass wet when checking. If the wiping condition is poor, it is necessary to clean the surface of the glass or replace the rubber wiper blade. If the condition is still not improved, please ask your Komatsu distributor to carry out inspection and repair. CHECK HORN Operate the horn switch and check that the horn sounds. If there is any abnormality, please ask your Komatsu distributor to carry out inspection and repair.
3 - 92 If the fuses f requently blow or if there are traces of sh ort circuits in the electrical wiring , locate th e cause and immediately pe rform repa irs, or contact y our Komatsu distributor fo r repairs . Ke ep the top surface of the b attery clean a nd check the breather hole in t he battery c ap. If it is clogg ed with dirt o r dust, wash th e battery c ap to clean the b reather hole. Che ck that th ere is no dam age to the fuses ; tha t fuses of t he specified capacity are u sed; t hat t here is no disconnection or trace of sho rt-circuiting in the electr ic wirin g an d no damage t o the covering . Chec k als o that there is no loosened terminals. If a ny, tighten them.
Moreover, pa alternator. Be sure to ch Be s immediately. accumulated around CHECK INFLATION PRESSURE OF TIRE S Measure the i nflation pressu re with a tir e pressure gauge, while the tires are cool, before st arting work Che ck for dam age or wear t o the tires a nd the rims. Che ck for loos e wheel hub n uts (bolts). The proper inf lation pressure is shown b