. MAINTENANCE SERVICE PROCEDURE WARNING water, see 4 - 20 Coolant is toxic. When open the dr ain valve, be careful not to get coolant o If it gets in your eyes, flush your ey es with large amount of fresh water and see a d When changing the coolant or wh en handling the cooling water containin g coola nt that has bee n drained during repai r of radiator, please contact your Koma tsu distributor or request a specialis t company t o carry out the operation. Coolant is toxic. Do not let it flow into drainage ditc hes or spray it onto the ground surface. COOLANT is already diluted wit h distilled water, so it is not flammable.
( For details of the distilled "COOLANT AND WATER FOR D ILUTION (PAGE 4-5)"). Check t he density with a COOL ANT tester. Prepare a hose to use when fillin g with coolant. Prepare a container to catch dr ained coolant minimum 40 liters (10.57 US gal) capacity 1. Stop the machine on level gr 2. Remove bolts (1) (2 pieces) t 3. Check that the cooling wate enough to make it possible to t ouch the radiator cap surface by hand, then turn radiator cap (3) slowly until it contacts the re. stopper to release the pressu 4. Following this, push radiator c ap (3), turn it until it contacts the stopper, then remove it. 5.
Prepare a container to catch t he coolant and open drain valve (4) at the left of the fuel tank t 6. After draining the water, close water. 7. When the radiator is full, start the engine, and run it at low idle. Keep the engine running at l ow idle for 10 minutes until the more than 90°C (194°F). alve (4), and drain the water. coolant temperature reaches 8. Stop the engine, open drain v 9. After draining the water, clean the cooling system with cleaning agent. For the cleaning method, see the instructions for the cleaning agent. Close drain valve (4). 10. 11. Add coolant through the wate r filler port up to the mouth of the port. For details of the co DENSITY TABLE". 12.
To remove air in the coolant, ru n the engine for 5 minutes at low idle and for another 5 minutes (While running the engine, lea ve the water filler cap removed.)