Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 32 4. After th e cooling fan re verse rotation p ilot lamp on the machin monito r flashes, chec k that it light s up . T he fan i s set to rotat in reverse 5. Run th e engine at hig Select the time for run ning the engine at high idl e as follows according t o the condition of clogging. Norma l clogging: 1 to 2 minutes Excessive clogging: 2 to 3 minute 6. When the cleaning is completed, run the engine at low i 7. Press position (B) of c ooling fan r everse rotation switch 8. After th e cooling fan re verse rotation p ilot lamp on the machin monito r flashes, chec k that it goes ou t.

T he fan i s set to rotat in the normal direction 9. Run th e engine at low idle for approximately 10 s econd NOTIC E of cleaning only by using the reverse rotation of the cooling fan, mud and dirt possibly remain. In case of cl eaning only by u sing the reverse r otation of th e coolin g fan, mud and dirt possibly remai If switching the cooling fan r otation to the normal direction in this s tate, the mud a nd d irt probably sti ck fast again to the fin, Afte r revers e rotations of the cooling fan, stop the engine a nd clear the r emaining mu d and dirt off by using compressed air broom, etc. confirm that there is no flammable material around hot portions of the engine.

In addition, confirm that ther e is no flammable material aro und hot portions of the engine.