. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL WARNING water. NOTICE 4 - 49 Parts and oil are stil l heated for some time aft er the engine stops. Start operations after the tempe Before the check, se t the gear shift lever to the P (PARKING ) position to prevent the machine from m oving and confirm th at the respective levers ar e placed in the neutral pos Carry out this proce dure if there is any sign of oil on th e transmission case, or if there is o il mixed with the co oling 1. Stop the engine. Wait for at least 12 hour s after stopping the engine before carry ing out the i nspection.
If this is not done , there will be oil remaining at various places and i t will be impossible to che ck the oil lev el correctly. 2. Remove cap of oil filler (F). stick (G) and wipe off the oil with cloth. ick (G) into filler pipe, then remove it. 3. Take out the dip stick (G) and wipe off th e oil with c loth. 4. Fully insert dipst ick (G) into filler pipe, t hen remove 5. The oil level sho uld be between the H a nd L marks on dipstick (G). If the oil level is below the L mark, add o il through o il filler port (F). 6. If the oil level is H line or above, remov e drain plug (1), slowly loosen drain plu g (2) to discharge the excess oil, and then el again.
e then check the oil lev Tightening torqu drain plug (1) : 59 to 78.5 Nm (6 to 8 kgm, 43.4 t o 57.9 lbft) drain plug (2) : 49 to 78.5 Nm (5 to 8 kgm, 36.2 t o 57.9 lbft)