Komatsu — EVERY 500 HOURS SERVICE

.

MAINTENANCE SERVICE PROCEDURE CHECK CIRCLE GUIDE CLEARANCE, ADJUST WARNING NOTICE 4 - 60 If there is no cleara nce between the root of the teeth (or the tip of the teeth) of the pinio n gear of the c ircle rotator an d the tip of the t eeth (or the root of the teeth) of the circle gear after mai ntenance has b een carrie d out, r eplace the guide When r aising the bl ade, do not raise it high If the condition remain s as below even after m aintenance is carrie d out, replace t he circle When t here is no cl earance (R) between the circle and circle g When t here is no cl earance between the roo t of the teeth (or th e tip of the teeth ) of the pi nion gea r of th e circle rotato r and the ti p of th e teeth (or t he root of the teeth) of t Prepar e the follo Feeler gauge Shims (thickness :

1 mm (0.039 in), 0.5 mm (0.020 in); 2 types) CHECKIN G 1. t 2. 1. Raise the blade and use a feeler gaug e to measure cle arance (P) be tween th e botto m fac e of the drawbar a nd he to p face of 0 in). the swing circle as shown in the diagram. The standard clearance is 1.5 ± 0.5 mm (0.059 ± am. arance 0.5 0.05 ± 0.02 2. Keep the blade r aised and use a feeler gauge to measu re clearance ( Q) F (fron t), (Q) C (center), and (Q) R (rear) between the cir cle and circle guide as shown in the dia gram when fo rce is ap plied a t the rear Standard cleara nces (Q) F, (Q) C, an d (Q) R are as fo llows.

(Q) F = 0 mm, ( Q) C = 0.7 mm (0.028 in), (Q) R = 1.5 mm (0.059 in) , or (Q) F = (Q) R = 1 mm (0.039 i