Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE in). (15) Pinion gear 4 - 62 Adjusting front and rear po Lower the blade lightl loosen locknut (4), tur (2), and make (Q) F = n back bolt (3), push open ci 0. (When doing this, push op rcle guide en the left and right bolts uniform 3. Adjust circle (14) fore a nd aft so that the clearance (D ) between the lower flange (13) of the circle rotator and the slidi ng surface of inner circumference 0.8 to 0.9 4. When (Q) F = 0, tighte n locknut (4), then tighten bol 5.

Adjusting left and right Loosen bolt (9), then l position oosen locknut (12), turn back bolt (11), push open circle guide this, push open the left (10), and make (Q) R = 0. (W and right bolts uniformly.) hen doing 6. Loosen bolt (5), then lo osen locknut (8), turn back bol t (7), push open circle guide (6), a nd make (Q) C = 0. (When doing this, push open the left and right bolts uniformly.) 7. When (Q) R = 0, turn b ack bolt (11) half a turn, tight en locknut (12), return circle guid tighten bolt (9). e (10) until it contacts bolt (11), then n the tip of the teeth of the circle gear 8.

The clearance betwee and the root of the teet h of the pinion gear should be 1.5 to 3.0 mm (0.059 to 0.118 in) . 9. When (Q) C = 0, turn b ack bolt (7) 1/4 of a turn, tight en locknut (8), return circle guide (6) until it contacts bolt (7), th en tighten bolt (5). 0º to the left and right at high bank. 10. Check that it rotates 9 0º to the left and right at high