SERVICE MOWER 3. Slide mower under machine. c CAUTION: Avoid injury! Component is spring-assisted and under tension. Injury can occur if spring-assisted component is released suddenly. 4. Put wood blocks under each side of mower deck. 5. Put attachment lift lever in lowest position. C C G H B A 6. Fasten rear draft arm (A) and adjustable lift link (B), on each side, with washers and spring locking pins (C). MX16568 MX25905 8. Put mower drive belt on engine drive sheave (G). Picture Note: 122 cm (48 in.) mower deck used for photo purposes. 10. On machines with 107 cm (42 in.) mower deck: Attach mower engagement drive cable. Service Mower - 32 IMPORTANT: Avoid damage!
To prevent clutch damage, make sure front draft rod is installed correctly. Secure rod with washer and spring locking pin on the left side of mower deck bracket. • On 122 cm (48 in.) and 137 cm (54 in.) mower decks: Put a 15 mm closed wrench or a socket on the idler sheave nut (H) and rotate clockwise, moving idler sheave and tensioning arm toward front of tractor. Hold while installing belt on drive sheave. I MX10521Y • On 107 cm (42 in.) mower deck: Make sure belt is routed through both belt guides (I). 9. Remove wood blocks from both sides of mower deck. ure front draft rod is installed correctly. Secure rod with washer nd spring locking pin on the left side of mower deck bracket.
E D F MX10521Y Picture Note: 107 cm (42 in.) mower deck shown. 7. Install front draft rod (D) into mower deck bracket (E) and secure with washer and spring locking pin (F) on the left side of bracket as shown. E D F MX10521Y Picture Note: 107 cm (42 in.) mower deck shown.